Based on the electronic system operation of the equipment, CNC machine tools soak water is to let a lot of manufacturers incomparable headache.
In some of the lower ground, easy to get into the water workshop, we must do a good job in advance to prepare for waterproofing, try to avoid this situation, but if you really encountered a machine tool into the water don't panic, with the editorial together with the rational operation, can certainly help you save some losses!
1】Machine parts
1.1 Thoroughly clean the machine tool and all parts, be sure to rinse out the residual mud and sand, disassemble and clean up and fully dry when necessary.
1.2 After drying, it should be fully oiled and lubricated to avoid corrosion, affecting the accuracy.
1.3 In case of serious corrosion, it is necessary to replace the screw and bearing.
2】Electrical parts
2.1 Disconnect all the power supply.
2.2 Remove the soaked electrical components and clean them with alcohol, and dry them sufficiently.
2.3 Carefully test the circuit, system interface and other parts to avoid short-circuit failure.
3】 Hydraulic part
3.1 Cannot switch on the motor oil pump, because the incoming moisture may enter the hydraulic piping system of the machine, leading to rusting of metal hydraulic components.
3.2 Replace all the hydraulic oil, wipe the tank clean with washing oil and clean cotton cloth before changing the oil.
4】Motor and control system
4.1 Electrical components and circuit boards are first cleaned with alcohol and dried for more than 24 hours;.
4.2 Clean the motor bearings with petrol and check if they can be used, otherwise replace the bearings with the same specification.
After some rescue with the editor, I believe you can certainly minimise equipment losses. Polyfull Intelligent Technology is willing to do your equipment maintenance of small helpers, choose us, must live up to the trust.